Installing Aluminum Driveshaft on a 2001 Ford Mustang GT Bullitt
Posted: Wed Apr 22, 2015 3:19 pm
Disclaimer! Warning this is to be used as a guide and I will not be held responsible if anything goes wrong or you break anything. DO THIS AT YOUR OWN RISK!
Installing Aluminum Driveshaft on a 2001 Ford Mustang GT Bullitt
Installed on: 5/25/2002
Total Install time: 2 hours
Photo one:
Here's a photo of 2001 bullitt #2610 all jacked up and ready for her install
Photo two:
Here's a pic of the new driveshaft on top and the old driveshaft on the bottom.
Photo three:
Here's a pic of the tranny when the stock driveshaft is removed.
Photo Four:
Here's another pic of the stock D/S removed at the rear axle.
Photo Five:
Here's the final product installed. Overall it was fairly easy mod to install. Getting the yellow dot on the rear axle to line up with the yellow dot on the driveshaft had to be the hardest part.
Installing Aluminum Driveshaft on a 2001 Ford Mustang GT Bullitt
Installed on: 5/25/2002
Total Install time: 2 hours
Photo one:
Here's a photo of 2001 bullitt #2610 all jacked up and ready for her install
Photo two:
Here's a pic of the new driveshaft on top and the old driveshaft on the bottom.
Photo three:
Here's a pic of the tranny when the stock driveshaft is removed.
Photo Four:
Here's another pic of the stock D/S removed at the rear axle.
Photo Five:
Here's the final product installed. Overall it was fairly easy mod to install. Getting the yellow dot on the rear axle to line up with the yellow dot on the driveshaft had to be the hardest part.